DOCK PROTECTION AND MAINTENANCE PRODUCTS

Product Coating Type Description

SP-1288

Epoxy SP-1288 G.P. Epoxy is a two-component ambient cured epoxy based on novel leading edge technology. SP-1288 G.P. Epoxy can be used in applications where abrasive blasting is not possible or feasible. SP-1288 G.P. Epoxy exhibits excellent adhesion on metal substrates prepared as per SSPC SP-11 Surface Preparation Specification.

SP-1386

Polyurethane Recommended uses for coating of On-shore and off-shore structures and pipe, sewer lines, general piping, dam gates, penstocks, lining of tanks and sewage digesters, lining of open-top gondola railcars used for transporting sulphur and coal. Advantages: good flexibility, excellent resistance to sea and fresh water, good acid and abrasion resistance, excellent adhesion to steel surfaces, fusion bonded epoxy, Fiber Reinforced Plastic and concrete.

SP-1853

Polyurethane Used for coating of ship decks, on-shore and off-shore structures and marine piles.

SP-1864

Polyurethane Used for coating of ship hulls, rudders, marine pilings, docks and ballast tanks. Ideally used for coating of pipe intended for slip bore/directional drill applications and for rehabilitating large sections of existing pipeline with automated equipment. Also for coating of pipe, valves, fittings, fabricated assemblies, girth welds, rehabilitation (recoating) of existing pipelines and coating repairs.

SP-2830

Epoxy / Amine Used for grouting and sealing purposes on pipeline prior to installation of repair/reinforcing sleeves or clamps, hot tape fittings and split sleeve fittings.

SP-4888

Epoxy Used for coating pipelines, structures or other steel surfaces where the surface is damp due to environment, high humidity or condensation. Advantages: excellent adhesion to wet, damp or dry grit blasted steel surfaces, Fusion Bond Epoxy, and Fiber Reinforced Plastic.

SP-5818

Epoxy DISCONTINUED. Excellent corrosion protection for steel structures, bridges, tanks, piping, valves, and other steel surfaces exposed to coastal and/or moderate to severe industrial environments.

SP-5819

Polymer Used as a tie-coat on well cured two-component coating in areas where abrasive blasting cannot be employed.

SP-5885

Epoxy SP-5885 SF replaces SP-5885. It is used for lining of tanks, piping and structures containing salt water, jet fuel, aliphatic hydrocarbons and associated products. Also used as corrosion resistant coating for structural steel, storage tanks and equipment in refineries pulp and paper mills and chemical plants.

SP-6888

Epoxy Used for coating of pipe, valves, fittings, girth weld coatings, tank lining, rehabilitation of existing pipelines and slip bore/direction drill applications. Advantage of excellent adhesion to grit blasted steel surfaces, fusion bond epoxy, liquid epoxy, and urethane coatings.

SP-6889

Epoxy Used for lining of ballast tanks and penstocks. It is a corrosion resistant coating for structural steel, storage tanks, and equipment in refineries, pulp and paper mills and chemical plants. Advantages: good adhesion to marginally prepared surface, single coat application to mil thickness normally requiring two or three coats.

SP-9887 GF

Novolac Epoxy SP-9887 GF is a Glass Flake reinforced Novolac epoxy coating for use on tanks, pipes, steel structures, offshore platforms and subsea structures. SP-9887 GF cures to form a coating film with overlapping layers of glass flakes that resists water and chemical permeation. SP-9887 GF can be used as a lining for storage tanks, ballast tanks, separation vessels, sewage tanks and digesters, waste troughs, and pipelines containing crude oil.
 
       
© 2003 Specialty Polymer Coatings Inc.